Control Data Corporation CYBER 170 Series Operator's Manual page 269

en
o
~
~
til
en
o
o
t"'4
tp
CO
til
"' - -
-
\,
"--
MESSAGE
TRACK LIMIT.
TRACK LIMIT. EQxx.
TRN - ABNORMAL.
TRT LENGTH ERROR.
TRUNK. name,status,node/port,remote/port
TTxx, FNff, FUNCTION TIMEOUT.
"' - ----
"
~-
/
SIGNIFICANCE
All mass storage devices available for
temporary files are full. CIO cannot
finish processing until space is available
on one of the devices. Operator message.
Mass storage device with EST ordinal xx has
no allocatable tracks left. CIO cannot
finish processing until space is available.
Operator message.
A TAF-originated task could not be scheduled
because of a lack of communication blocks or
ITASK queue was full. An attempt to
schedule the task will be made at a later
time.
Operator message indicating that an error
was encountered while reading the track
reservation table (TRT) during a level 0
deadstart. Preceded by message RECOVERY,
dtxx, which indicates the equipment in
error.
dt Device type
xx EST ordinal
Trunk status message sent in response to a
STATUS command, or when a significant change
in status has occurred.
name Name of trunk; UNKNOWN implies the
trunk is disabled and the NOP is
being informed of the change in
status.
status Status of trunk
DI Disabled
EN Enabled
AC Active
DN Down
node Node number
port Port number
remote Remote node number
The driver routine .(lTD) issued a function
to the multiplexer and did not receive an
inactive signal Yithin four major cycles.
This error causes the subsystem to abort.
xx EST ordinal of multiplexer
ff Function
ACTION
Inform site analyst.
Inform site analyst.
Inform 'site analyst.
Redeadstart and
initialize device.
Preserved files on
device are lost,
and must be reload-
ed.
No action required
if response to STATUS
command. Check dayfile
for subsequent messages
which might indicate a
change in status.
Inform customer engineer.
"---
ROUTINE
CIO,
DSP
CIO
TAF
RMS
NS
lTD