Control Data Corporation CYBER 170 Series Operator's Manual page 4

REVISION RECORD
REVISION
DESCRIPTION
A Manual released. This manual supports NOS 1.0 at PSR level 404.
(06-15-75)
B Manual revised to support NOS 1.1 at PSR corrective code level 419/420. This edition obsoletes all
(03-08-76) previous editions.
C
Manual revised to support NOS 1.2 at PSR corrective code level 439 and to make editorial and technical
(12-03-76) corrections. New features documented in this manual include: support of N AM (Network Access Method), RBF
(Remote Batch Facility), and TAF (Transaction Facility); 844-44 Disk Storage Subsystem; I/O queue and dayfile
utilities QDUMP, QLOAD, QMOVE, and LDLIST; device types NP (2550 Host Communications Processor), LS (580-16
Line Printer), and LT (580-20 Line Printer); FORM and KILL commands; and detection of power/environmental
failure. This edition obsoletes all previous editions.
D Manual revised to support NOS 1.2 at PSR corrective code level 452 and to make editorial and technical
(07-15-77)
corrections. Support of CDC CYBER 171 is included. The S display is expanded to show service limits in addition to
queue priorities. Error messages in appendix B are reformatted.
E Manual revised to support NOS 1.2 at PSR corrective code level 460 and to make editorial and tec!'mical
(10-21-77)
corrections. Procedures to deadstart from a 669 tape unit using a 7152 tape/disk controller are included. The DIS
command RE,xx. is removed.
F
Manual revised to support NOS 1.3 at PSR corrective code level 472 and to make editorial and technical
(05-17-78) corrections •. New features documented in this manual include: support of IAF (Interactive Facility) and CDCS (CDC
CYBER Database Control System); command VALIDATE,xx.; 844 disk full tracking capability (device types DK for
full track 844-21 and DL for full track 844-41/44); on-line reconfiguration of mass storage using the REDEFINE·
command (section 6) and mass storage configuration (E,C.) display; user capability to access ECS; detection of fatal
mainframe errors (appendix G); and support of 677/679 magnetic tape units. Refer·ences to the 841 disk drive, 512
line printer, and 657/659 magnetic tape units are removed. Former sections 5 (Permanent File Utilities) and 6
(Queue/Dayfile Utilities) have been removed and are contained in the System Maintenance Reference Manual.
Operation Under DIS Control, formerly section 8, is now section 5. Machine Recovery Utility, formerly section 9, is
now section 8. Section 7, Network Operator and Local Operator Commands, replaces comparable sections from the
Administrator and Operator Facility Reference Manual. This edition obsoletes all previous editions.
G
Manual revised to support NOS 1.3 at PSR level 477 and to make technical corrections. Changes are made
(08-25-78)
to the following displays: CDC CYBER 170 Series Memory Check (section 2), E, T, H, Q,S, T, and MREC right
screen command descriptions of DELAY, MESSAGE, and UNLOAD have changed .
H
. Manual revised to support NOS 1.3 at PSR level 485 and to make technical corrections.
(12-22-78)
Publication No.
60435600
REVISION LETTERS I, 0, Q AND X ARE NOT USED
©
1975,1976, 1977, 1978, 1979, 1980
by Control Data Corporation
All Rights Reserved
Printed in the United states of America
ii
Address comments concermng this
manual to:
Control Data Corporation
Publications and Graphics Division
4201 North Lexington Avenue
St. Paul, Minnesota 55112
or use Comment Sheet in the back of
this manual.