-
t p
Co)
00
en
Q
~
Co)
(11
en
Q
Q
t:"' 4
MESSAGE
ERROR LOADING -DIO-.
ERROR ON ACTIVE DEVICES.
ERROR ON DEVICE WITH ACTIVE FILES.
ERROR ON xxJ FILE ARGUMENTS.
ERROR ON LINK DEVICE.
ERROR ON LINK DEVICE.
EST/FNT LENGTHS CONFLICT, RECOVERY OF DEVICE
IMPOSSIBLE.
EXPORT ABORT - NO MUX OR BAD MUX.
SIGNIFICANCE
A character was found after the
postradix.
An 8 or 9 was found with a postradix of
B specified.
.
The position number was greater than the
number of units in the equipment to be
reconfigured.
The record on the deadstart file immediately
following OSB is not DIO.
Label checking has detected error on device
with active files.
Message indicates
abnormal condition that should be corrected
immediately (for example, wrong pack removed
when interchanging
devices)~
This message is issued during level 1 or 2
recovery deadstart if label on mass storage
device cannot be verified and active files
are on the device.
Recovery is impossible.
This message is preceded by the message
RECOVERY, dtxx.
which indicates the equip-
ment that is in error.
The xxJ file contains statements in error,
which causes the transaction subsystem to
abort.
An
unrecoverable read error was encountered
while reading the ECS label track.
An
unrecoverable error occurred while
reading the link device.
Error was encountered during a recovery
deadstart.
This error occurred because the
length of the FNT or EST of the system
defined in CMRDECK conflicts with the system
being recovered from disk.
The Export driver was unable to obtain a
satisfactory status reponse from an
assigned multiplexer during initialization.
Dayfile message.
ACTION
Select a different tape
or
dis~
from which to
deadstart.
Examine E,M display to
determine type of error.
Attempt another deadstart
with no recovery (level
0).
Examine xxJ file.
Consult TAF data base
administrator.
Inform site analyst;
deadstart may be
required.
Inform customer engineer;
error should be logged in
error log.
Attempt another
deads~art
without recovery (level
0).
Inform site analyst.
ROUTINE
OSB
CMS
RMS
TAF
RDM
IMS,
lCK
REC
lLS
Need help?
Do you have a question about the CYBER 170 Series and is the answer not in the manual?