Control Data Corporation CYBER 170 Series Operator's Manual page 237

C)
o
~
c.,)
c.n
C)
o
o
t"I
tp
C)
c.,)
~/
\'--'./
-
~-j
MESSAGE
MTxx, NEEDS LABEL.
MTxx, RING CONFLICT.
MTxx, WRONG VSN.
MTS FIRMWARE NOT FOUND.
MUX TABLE OVERFLOW.
NAM ERROR - ILLEGAL ABR.
NAM ERROR - ILIDGICAL ABT.
NAM FUNCTION NOT FOUND.
NAM INITIATED INCORRECTLY - TRY N.NAM.
NAM LOGICAL ERROR.
"--J ~
SIGNIFICANCE ACTION
Tape mounted on 7-track magnetic tape unit Mount correct tape.
with EST ordinal xx is unlabeled and the job
requires a labeled tape. On labeled
. multireel files, all subsequent reels must
be labeled. If NT appears in place of MT,
the message indicates a 9-track tape unit.
For a 9-track tape unit, this message can
mean that a subsequent reel was mounted on
the same unit as the previous reel, and it
is labeled in the wrong conversion mode.
Ring status for 7-track tape mounted on
magnetic tape unit with EST ordinal xx
conflicts with ring status requested by the
job. If NT appears in place of MT, message
indicates a 9-track tape unit.
Tape mounted on 7-track magnetic tape unit
with EST ordinal xx does not have the volume
serial number (VSN) requested by the job.
If NT appears in place of MT, the message
indicates a 9-track tape unit.
Magnetic tape conroller controlware is not
in the system.
Space sufficient to allocate the required
table was not available. An internal change
to the time-sharing executive is necessary.
The applicat~on block header (ABR) sent to
TAF by NAM is unrecognizable.
The application block type (ABT) sent to
TAF by NAM is unrecognizable.
TAF received a supervisory message from NAM
which had an unrecognizable primary or
secondary function code.
The operator attempted to initiate the
network with the
co~mand
X.NAM which is
incorrect.
NAM
sent TAF a message out of order or an
unrecognizable message.
Correct. ring status
(insert or remove write
ring) and remount tape.
Mount tape with correct
VSN as shown on the
resource mounting preview
(E,P.) display •.
Inform site analyst.
Inform site analyst.
Inform site analyst.
Inform site analyst and
refer to the NAM
Reference Manual.
Perform a dump of TAF
and NAM or inform site
analyst •.
Initiate the network
with the n.NAM command
(refer to section 3).
Inform site analyst.
.
"-----/
ROUTINE
DSD
DSD
DSD
1MT
IAFEX,
TELEX
TAF
TAF
TAF
NIP
TAF
~'