Control Data Corporation CYBER 170 Series Operator's Manual page 263

en
Q
~
~
c.n
en
Q
Q
t"'
tp
co
(,0
"'-_/
~
/
-
' "
MESSAGE
SWITCH PACK/SPIN UP UNIT xx.
SYSTEM ACTIVITY PROHIBITS LIBRARY CHANGE.
SYSTEM BUILT WITH LIBDCKn.
or
SYSTEM BUILT WITH LIBDCKn. (UNDEFINED)
~,:
SIGNIFICANCE
0070 Not a SUPIO file
0071 Duplicate record ID
"' -
0072 Index pointers in FET are
unrecognizable
0073 Index area too small
0074 Random request on sequential
file
0075
Sequential request on random
file
0076 Rewrite longer than previous
record
0077 Rewrite on nonexistent record
1031 End-of-information on coded
file
1033 End-of-information on
binary file
4001 Write parity error; data not
transferred
4002 Unrecognizable write address
error; data not transferred
4003 Unrecognizable write, detail
status error; data not
transferred
4007 Track limit
file Type of file on which error was
detected (NCF, LCF, or CCP).
Operator message indicating that pack can be
switched.
Dayfile message indicating that an error
occurred because the job at control point
cannot be moved in order to perform the
SYSEDIT.
Informative message following a level 0
(initial) or level 2 (recovery) deadstart to
indicate the LIBDECK with which the system
was generated. The second form of the mes-
sage is issued if the specified deck was not
found. This can seriously affect system
performance' because often used routines
which normally reside in CM or the alternate
system device (ASD) must be accessed from
the system disk instead.
n LIBDECK number
ACTION
new CCP can be assigned
before or after GO is
issued.
Switch physical pack
and activate unit xx.
Inform site analyst; the
recommended action is
one of the followng.
- Drop activity at
control point
1
Reduce size of CMR
resident to allow
building of tables
within the
allocated field
length.
Redeadstart if necessary
to rebuild system using
a known LIBDECK.
',,-
ROUTINE
RDM
SLL
SYSEDIT