Control Data Corporation CYBER 170 Series Operator's Manual page 249

C)
o
~
c:,.)
til
C)
o
o
~
~
til
\,~-
"'--j
MESSAGE
PARITY ERROR ON DATA XMTD FROM
EXTERNAL PP.
PERIOD REQUIRED
PF LENGTH ERROR userin filename
PF LINKAGE ERROR.
PFC RELOAD ERROR.
pfn FOR j obname NOT FOUND ON MSF.
REPLY GO TO CONTINUE
PFM ERROR ec ON filenam
"--./
PFM ERROR ec PFN= filename
UNa
usernam.
"---./
"--~
SIGNIFICANCE
A parity error was detected on data
transmitted from a PP.
A comment entry on the editing display for
CYBERLOG did not terminate with a period.
Interlock data in system sector of queued
file indicates that the last sector of the
file (specified by TRT) was not an EOI
sector.
userin User index of file in error
filenam Name of file on which error was
encountered
Operator message indicating that an error
was encountered while recovering a preserved
file during a level 0 deadstart. Preceded
by message RECOVERY,dtxx, which indicates
the equipment in error.
dt Device type
xx EST ordinal
K-display message indicating that the PFC
entry for a file being staged from MSF to
disk did not correspond to the file data on
MSF. A probable cause of this system error
is the use of obsolete permanent file dump
tapes for reloading a device or a set of
permanent files.
pfn Permanent file name
jobname Job name
An
error was detected on the file by the
permanent file manager.
ec Error code. Refer to the NOS
Reference Manual, volume 2 for
PFM error codes.
filenam Type of file on which error was
detected (such as NCF, LCF, CCP,
and so on). .
MCS could not attach indicated file.
ec PFM error code
filenam File name
usernam User name
ACTION
Inform site analyst and
customer engineer.
Enter a period.
Inform site analyst.
On a level 3 recovery,
the system sets error
idle status for the
device~ On a level 0
recovery, enter n.DROP
to set error idle status
for the device. Enter
n.GO to continue
recovery.
Redeadstart and
initialize device.
Preserved files on
device are lost,
and must be re-
loaded.
Ensure that obsolete
dump tapes were not used
and if they were, take
appropriate action.
Enter K.m.GO to clear
the message.
m Message ordinal
For file types NCF, LCF,
and CCP, this message
is followed by the
message
type NOT AVAILABLE
where type is CCP, LCF,
or NCF. Refer to that
message for appropriate
action.
Refer to the NOS
Reference Manual,
volume 2 for a list of
the error codes.
\
ROUTINE
SCE
CYBRLOG
REC
RMS
EXSTGE
NS,
CS,
NVF
MCS
\
I