Toro Greensmaster eTriFlex 3360 Service Manual page 97

Removing the Exhaust System (continued)
Installing the Exhaust System
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
2. Remove the hood and rear wheel assembly for additional clearance if
desired; refer to Removing and Installing the Hood Assembly (page 6–43)
and Removing and Installing the Wheels (page
3. Remove the fasteners securing the muffler to the engine frame.
4. Remove the fasteners securing the exhaust pipes to the cylinder heads, and
remove the muffler assembly from the machine. Retrieve the two conical
washers from the muffler brackets. Retrieve and discard the exhaust gaskets.
5. Continue to dismantle the muffler assembly as needed.
6. Remove any gasket material from the exhaust pipes or cylinder heads.
1. Loosely assemble the muffler, exhaust pipes, clamps and heat shield.
2. Use new exhaust gaskets and fit the muffler assembly to the machine.
3. Install all the fasteners used to secure the muffler assembly loosely. Ensure
the conical washer is installed between the muffler brackets and the engine
frame brackets in the direction shown; refer to
g286390
1. Conical washer
2. Flange nut
3. Engine frame bracket
4. Secure the muffler assembly to the machine:
A. Tighten the fasteners at the cylinder heads from 12 to 17 N·m (9 to 13
ft-lb).
B. Tighten the muffler clamp fasteners from 14 to 25 N·m (175 to 225 in-lb).
C. Tighten the muffler bracket fasteners.
5. Install the rear wheel assembly; refer to
(page 6–9)
6. Install the hood assembly; refer to
Assembly (page 6–43).
Figure 14
4. Muffler bracket
5. Shoulder screw
Removing and Installing the Wheels
Removing and Installing the Hood
Page 4–11 Engine (Model 04580): Service and Repairs
6–9).
Figure 14.