Toro Greensmaster eTriFlex 3360 Service Manual page 253

Adjusting the Brake Cable (continued)
g283646
1. Brake actuator
2. Rod nut
3. Clevis nut
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
5. Use the 3/8 inch square drive hole in the right side upper brake arm to fully
extend the brake actuator.
6. The gap between the brake actuator rod nut and the actuator clevis nut
should be 3.3 to 3.8 mm (0.13 to 0.15 inch) and the clevis pin holes should
be parallel to the ground. Loosen the clevis nut and adjust the clevis if
necessary.
4. Clevis
5. Extension spring
6. Eye bolt
7. Install the extension spring and adjust the eye bolt until the extension spring
is 114 to 117 mm (4.50 to 4.63 inch) inside the spring hooks. Tighten the
eye bolt hex nuts.
8. Check the brake adjustment; refer to
6–3).
Figure 118
Checking the Brake Adjustment (page
Page 6–7
7. Hex nuts (2 each)
Chassis: Adjustments