Toro Greensmaster eTriFlex 3360 Service Manual page 64

Machine Faults (continued)
Fault
Fault Title
ID
P156C Traction
Controller
- Internal
Hardware
Failure
P156D Traction
Controller
- Internal
Software
Failure
P156E Traction Motor
Software -
Hardware
Incompatibility
P1A01 Battery
Charging - High
Temp Shutdown
P1A02 Battery
Charging- Low
Temp Shutdown
P1A11 Battery
Charging
Voltage - High
Troubleshooting: Battery Charger Error and Fault Codes
(Model 04590)
Fault
Controller(s)
Condition/Circuit
Affected
Description
SC5, SC6 An internal
component of
the controller
fails in the
indicated
traction motor
controller.
SC5, SC6 An unexpected
software error
occurs in
the indicated
traction motor
controller.
SC5, SC6 The software is
not compatible
with the
hardware in
the indicated
traction motor
controller.
SC8 A Li-ion battery
cell temperature
is greater than
60° C (140° F).
SC8 A Li-ion battery
cell temperature
is less than -10°
C (14° F).
SC8 A Li-ion battery
cell voltage is
greater than
4.2V.
Additional Notes Service Actions
Traction is 1.
disabled.
2.
3.
Traction is 1.
disabled.
2.
3.
Traction is 1.
disabled.
2.
3.
Battery contactor 1.
in Li-ion battery
controller is
2.
opened.
3.
Battery contactor 1.
in Li-ion battery
controller is
2.
opened.
Battery contactor 1.
in Li-ion battery
controller is
2.
opened.
3.
Page 3–28
Replace and program the traction
motor controller (contact an Authorized
Toro Distributor for assistance).
Cycle the key switch.
Use the InfoCenter to calibrate the
traction motor controller.
For SC5, calibrate the traction pedal
first, then the traction motors.
For SC6, calibrate the traction motors.
Replace and program the traction
motor controller (contact an Authorized
Toro Distributor for assistance).
Cycle the key switch.
Use the InfoCenter to calibrate the
traction motor controller.
For SC5, calibrate the traction pedal
first, then the traction motors.
For SC6, calibrate the traction motors.
Replace and program the traction
motor controller (contact an Authorized
Toro Distributor for assistance).
Cycle the key switch.
Use the InfoCenter to calibrate the
traction motor controller.
For SC5, calibrate the traction pedal
first, then the traction motors.
For SC6, calibrate the traction motors.
Allow the machine to cool before
charging.
Disconnect the charger for 5 seconds
and then reconnect.
Charge the machine in the shade or a
cooler environment.
Allow the machine to warm before
charging.
Disconnect the charger for 5 seconds
and then reconnect.
Ensure the correct charger is being
used.
Check the charger for faults.
Charge the machine with a known
good charger or replace the charger.
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B