Toro Greensmaster eTriFlex 3360 Service Manual page 273

Removing and Installing the Brake Pedals (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
2. Disconnect the brake cable from the brake pedal and pedal support (remove
2 retaining rings).
Note: Record the location of any cable ties securing the wire harness to the
machine, and replace them during assembly.
3. Disconnect the manual parking brake switch from the machine wire harness.
Check the switch and the harness connector for damage or corrosion and
clean or repair as necessary.
4. Remove the 3 fasteners securing the brake pedal support to the left platform,
and remove the assembly from the machine.
5. Repair or replace the brake pedal components as necessary.
6. Ensure the park pedal (item 12) moves freely with the torsion spring.
7. Check and adjust the manual parking brake switch if necessary; refer to
Adjusting the Manual Parking Brake Switch (page
8. Secure the brake pedal assembly to the platform.
9. Connect the brake switch to the machine wire harness and secure the wiring
to the machine.
10. Install the brake cable with the 2 retaining rings previously removed. Adjust
the brake cable; refer to Adjusting the Brake Cable (page
Page 6–27
5–22).
6–6).
Chassis: Service and Repairs