Toro Greensmaster eTriFlex 3360 Service Manual page 252

Adjusting the Brake Linkage (continued)
Adjusting the Brake Cable
Chassis: Adjustments
7. Ensure the flat side of the lower brake rod clevis is toward the traction motor
and install the clevis pin with a new cotter pin.
8. Adjust the brake cable; refer to
1. Park the machine on a level surface, set the key switch to the O
and remove the key.
2. Loosen the hex nuts and adjust the eye bolt as far as possible to relax the
extension spring. Remove the spring.
g283623
1. Front traction motor – RH
2. Hex nut (2 each)
3. Eye bolt
3. Use the 3/8 inch square drive hole in the right side upper brake arm to fully
retract the brake actuator.
The brake cable must not restrict the brake actuator from fully
retracting.
4. Loosen the brake cable adjuster jam nuts and adjust the cable until only a
small amount of free play exists in the brake pedal. Tighten the adjuster
jam nuts.
Adjusting the Brake Cable (page
Figure 117
4. Extension spring
5. Upper brake arm – RH
6. Brake rod assembly
IMPORTANT
Page 6–6
6–6).
position
FF
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B