Servicing the Rear Wheel Gear Box (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
7. Remove the rear traction motor if necessary; refer to
(Optional) (page
5–133).
8. Inspect and replace all of the gear box components as necessary. Ensure all
bearings are pressed fully against their respective shoulders.
9. Assemble the gear box in reverse order. Use a new axle shaft seal and
housing gasket. Tighten the gear box cover fasteners in a crossing pattern
to 15 N·m (11 ft-lb).
Page 6–21
Rear Traction Motor
Chassis: Service and Repairs