Toro Greensmaster eTriFlex 3360 Service Manual page 283

Installing the Steering Arm (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
The gas cylinder is under high pressure at all times. Avoid pressing
the gas cylinder release pin while either end of the cylinder is not
secured to the machine. Do not open the gas cylinder.
3. Install the gas cylinder:
A. If previously removed, fully thread the end of the gas cylinder into the
pivot lever.
B. Install the pivot lever and gas cylinder as an assembly then install the
retaining ring (item 27).
C. Install the fasteners securing the gas cylinder at the steering arm, then
tighten the gas cylinder jam nut to 20 N·m (14 ft-lbs).
D. Install the pivot pedal (item 32) and the retaining ring.
4. If previously removed, install the steering mount in the position recorded.
5. Install the steering input device:
A. If previously removed, install the shaft adapter (item 11) to the steering
input device by pressing a new roll pin and installing 2 set screws.
Tighten each set screw from 8 to 10 N·m (70 to 90 in-lb).
The lower right mounting hole of the steering mount is larger to
accept an alignment feature on the steering input device body.
Ensure the steering input device is properly aligned with the
steering mount before installing the steering input device.
B. Install the steering input device using the fasteners previously removed.
C. Apply a light coating of anti-seize lubricant to the splines of the shaft
adapter and install the steering wheel.
D. Install the flat washer and lock nut, then tighten the lock nut from 27
to 35 N·m (20 to 26 ft-lb).
E. Install the steering wheel cap and screw.
6. Connect the steering input device to the machine wire harness and install the
cover (item 21).
7. Calibrate the steering system – center; refer to
System – Center (page
CAUTION
IMPORTANT
5–91).
Page 6–37
Calibrating the Steering
Chassis: Service and Repairs