Toro Greensmaster eTriFlex 3360 Service Manual page 103

Installing the Engine (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g286602
1. Engine
2. Engine pulley
The engine assembly weighs approximately 42 kg (92 lb). Use an
appropriate lift to install the engine assembly.
Make sure to not damage the engine, fuel or vent hoses, oil drain
hose, electrical harnesses, control cables or other parts while
installing the engine.
2. Secure the engine to the engine frame with the 4 cap screws previously
removed.
3. Remove the front engine lift lug and reinstall the fastener used to secure the
lift lug to the engine; refer to
4. Secure the drip pan to the engine frame.
5. Fit the starter/generator drive belt over the engine pulley and adjust the drive
belt tension; refer to
(Model 04580) (page
Figure 19
3. Set screw (2 each)
4. Square key
CAUTION
IMPORTANT
Figure 18.
Adjusting the Starter/Generator Drive Belt Tension
5–20).
Page 4–17 Engine (Model 04580): Service and Repairs