Toro Greensmaster eTriFlex 3360 Service Manual page 347

Installing the Idler Assembly (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
B. Press the bearing into the idler arm so that the bearing contacts the
shoulder in idler arm bore and install the bearing retaining ring.
C. Install the bearing shields with the flocked side of the shield toward the
bearing.
D. Insert the stub shaft through the shields and bearing. Use the through
hole in the shaft to prevent the shaft from rotating and tighten the flange
nut from 37 to 45 N∙m (27 to 33 ft-lb).
E. If the collar was removed from the idler arm, install the collar and tighten
from 33 to 41 N∙m (24 to 30 ft-lb).
2. Fit a new O-ring to the motor adapter.
3. Apply anti-seize lubricant to the outside diameter of the motor adapter and
position the idler arm over the adapter.
4. Use new lock nuts and secure the motor adapter and idler arm to the cutting
unit side plate.
5. Install the clevis pin and a new cotter pin to secure the height adjustment rod
to the front of the idler arm.
Page 8–13 Universal Groomer (Optional): Service and Repairs