Toro Greensmaster eTriFlex 3360 Service Manual page 295

Servicing the Cutting Unit Suspension Assembly (continued)
Installing the Cutting Unit Suspension Assembly
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g286889
1. Lower A arm
2. Counterbalance bracket
7. Install the cutting unit; refer to the traction unit Operators Manual.
8. Install the grass basket.
Refer to Figure 142 for this procedure.
1. Ensure all suspension components are correctly assembled.
2. Secure the suspension assembly to the machine with the 3 flange head
screws previously removed. Tighten the screws from 102 to 115 N·m (75
to 85 ft-lb).
3. Install the front wheel if previously removed; refer to
the Wheels (page 6–9).
4. If the stabilizer springs are removed, support the suspension assembly
so the spring bracket mounting hole is centered in the spring bracket slot
approximately 145 mm (5.72 inch) from the rear of the pivot mount (this is
the cutting unit transport position). Then, position the bracket so the center
of the spring end is 222 mm (8.74 inch) from the rear of the pivot mount.
Secure the spring bracket in position with the flange head screw.
Figure 144
3. Counterbalance tensioner
4. Clevis pin
Page 6–49
Removing and Installing
Chassis: Service and Repairs