Toro Greensmaster eTriFlex 3360 Service Manual page 230

Disassembling the Starter/Generator (continued)
Electrical System: Service and Repairs
9. Remove the spring bracket from the starter/generator housing.
Note: If the starter/generator housing/stator requires replacement, the
starter/generator assembly must be replaced. The starter/generator
housing/stator is not available separately.
10. Continue to disassemble the starter/generator if necessary:
g288751
1. Housing/stator assembly
2. O−ring
3. Bearing
4. Rotor assembly
5. Bearing
6. Wave washer
7. O−ring
Use of the starter/generator rotor tool part number TOR6029 is recommended
for this procedure; refer to
When servicing the starter/generator, use a clean work space with
a non-metal surface. The starter/generator rotor includes very
powerful magnets that can cause the rotor to move unexpectedly
if working on a metal surface. Also, any metallic debris that
gets attracted to the rotor can damage the starter/generator after
assembly.
Figure 103
8. O−ring
9. Cover
10. Flange screw (6 each)
11. Lip seal
12. Screw (2 each)
13. Isolator
14. Gasket
Generator Rotor Tool (page
IMPORTANT
Page 5–126
2–14).
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B