Toro Greensmaster eTriFlex 3360 Service Manual page 303

Leveling the Rear Roller (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g284061
1. Side plate
2. Shoulder bolt (2 each)
5. Adjust the position of the side plate so the rear roller contacts the bench plate
at both ends, making the rear roller parallel to the reel. Tighten the shoulder
bolts from 24 to 27 N∙m (210 to 240 in-lb).
6. Recheck the clearance between the rear roller and the bench plate. If
necessary, loosen and adjust second side plate on the side of the cutting unit
where the rear roller is low (contacting the bench plate).
7. Complete the cutting unit set-up and adjustment procedure.
Figure 149
3. Rear roller
Page 7–5 DPA Cutting Units: Adjustments