Toro Greensmaster eTriFlex 3360 Service Manual page 310

Installing the Bedknife (continued)
Grinding the Bedknife
DPA Cutting Units: Service and Repairs
g226894
6. Working from the center of the bedknife toward each end, tighten screws
from 23 to 28 N-m (200 to 250 in-lb).
7. After installing the bedknife to bedbar, grind the bedknife.
Bedknife Grinding Specifications
Standard Bedknife Relief Angle
Fairway Bedknife Relief Angle
Extended Bedknife Relief Angle
Front Angle Range
g207289
1. Top angle
2. Top surface
3. Remove burr
Since there can be variations in the mounting surface of the bedbar, it is
necessary to grind the bedknife after installing it to the bedbar. Follow
the bedknife grinding specifications provided; refer to
Specifications (page 7–12). Grind only enough so the top surface of the bedknife
is true; refer to Figure
Figure 154
Figure 155
4. Front surface
5. Front angle
155.
Page 7–12
3° minimum
3° minimum
7° minimum
13° to 17°
Bedknife Grinding
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B