Toro Greensmaster eTriFlex 3360 Service Manual page 271

Removing and Installing the Brake Linkage (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
1. Park the machine on a level surface, set the key switch to the O
and remove the key.
2. Loosen the hex nuts and adjust the eye bolt as far as possible to relax the
extension spring. Remove the spring.
3. Use the 3/8 inch square drive hole in the right side upper brake arm (item
8) to fully retract the brake actuator.
4. Disconnect the actuator clevis (item 12) from the link and brake shaft
assembly. Discard the cotter pin.
5. Remove the brake rod assemblies (item 20) from the machine. Discard the
cotter pins.
6. Disconnect the brake cable from the left side brake arm.
7. Remove the fasteners securing the brake shaft bearings (item 5) to the
machine, and remove the bearings and shaft as an assembly.
8. Repair or replace the brake linkage components as necessary.
9. Secure the brake shaft and bearing assembly to the machine.
10. Connect the brake cable to the left side brake arm.
11. Use a new cotter pin and connect the actuator clevis to the link and brake
shaft assembly.
12. Use new cotter pins and install the brake rod assemblies to the brake arms
only.
13. Adjust the brake linkage; refer to Adjusting the Brake Linkage (page
Page 6–25
position
FF
6–4).
Chassis: Service and Repairs