Toro Greensmaster eTriFlex 3360 Service Manual page 316

Inspecting the Reel Assembly (continued)
Installing the Reel Assembly
DPA Cutting Units: Service and Repairs
The seal must be installed with the flocked side of the seal toward
the bearing.
4. Slide the new flocked seals and press the bearings onto the reel shaft until
they contact the shoulder of the reel shaft.
Note: The reel nut on the left end of the cutting reel has a black finish and
has left-hand threads. The left end of the cutting reel shaft is identified with a
groove cut just inside of the left-most reel spider. The reel nut on the right
end of the cutting reel has a silver finish and has right-hand threads.
5. Install the reel nuts finger tight.
Refer to Figure 157 for this procedure.
1. Position the cutting unit on a flat work area.
2. If previously removed; attach the right side plate to the cutting unit frame.
Tighten the shoulder bolts from 24 to 27 N∙m (18 to 20 ft-lb).
3. Install the right side pitch arm.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when installing the cutting reel.
4. Apply a thin coat of grease to the outside of the cutting reel bearings and
carefully slide the cutting reel assembly into the right side plate. Make sure
that the reel bearing is fully seated in the side plate, and that the real nut on
the left (exposed) end of the cutting reel has a black finish.
5. Place the flat wire spring into the bearing bore of the left side plate. Install the
left side pitch arm and carefully slide the left side plate and pitch arm onto the
cutting reel assembly as far as possible.
6. Install the shoulder bolts and flange nuts that secure the left side plate to
the cutting unit frame. Tighten the shoulder bolts from 24 to 27 N∙m (18
to 20 ft-lb).
7. Install the rear roller; refer to
8. Install the front roller; refer to
9. Install the bedbar assembly; refer to
10. Tighten the reel nuts:
A. Insert a long-handled pry bar (3/8 x 12 inch with a screwdriver handle
recommended) through the front of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move.
IMPORTANT
CAUTION
Installing the Rear Roller (page
Installing the Front Roller (page
Installing the Bedbar (page
Page 7–18
7–25).
7–23).
7–7).
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B