Toro Greensmaster eTriFlex 3360 Service Manual page 323

Removing the Rear Roller (continued)
Installing the Rear Roller
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
2. Loosen the flange nuts that secure the rear roller retainer assemblies (flange
nuts, socket head screws, shaft retainer, spacer and shims) to the cutting unit.
Note: On cutting units equipped with the optional High Height-of-Cut Kit,
there will be additional roller shims installed between the rear roller and the
cutting unit side plate.
3. Remove one of the rear roller retainer assemblies.
4. Slide the rear roller assembly from the remaining retainer assembly.
5. Remove the remaining retainer assembly from the cutting unit if necessary.
Refer to Figure 164 for this procedure.
1. Place the cutting unit on a level work surface. Place blocks under the bedbar
to raise the rear of the cutting unit off of the work surface.
Note: Refer to the Cutting Unit Operator's Manual to determine the number
of shims required for the desired height-of-cut range.
2. If previously removed, install one of the rear roller retainer assemblies (flange
nuts, socket head screws, shaft retainer, spacer and shims) to the cutting unit.
3. Slide the rear roller shaft into the retainer assembly attached to the cutting
unit.
4. Install the remaining rear roller retainer assembly.
5. Center the rear roller in the cutting unit and tighten the flange nuts at each
of the retainer assemblies.
6. Check to make sure the rear roller and the cutting reel are parallel; refer to
Leveling the Rear Roller (page 7–4).
Page 7–25 DPA Cutting Units: Service and Repairs