Toro Greensmaster eTriFlex 3360 Service Manual page 243

Disassembling the Cutting Unit Motor (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
1. Inspect the cutting unit motor cable for wear or damage. replace cable
components or complete cutting unit motor assembly if necessary.
g289220
1. O-ring
2. Barb fitting
3. Hose
4. Convoluted tubing – 0.88 inch
5. Bulkhead fitting
6. Bulkhead nut (2 each)
7. Bulkhead fitting
8. Ferrule
2. Remove the 6 cap screws that secure the gear box cover to the front of
the motor housing.
3. Carefully slide the gear box cover from the front of the motor.
4. Remove and discard the O-rings from the gear box cover.
5. Carefully remove and discard the lip seal from the gear box cover.
6. Slide the output gear assembly from the motor housing and retrieve the
wave washer.
7. Remove the six cap screws that secure the motor cover to rear of motor
housing. Do not remove the motor cover at this time.
8. Secure the base plate of the cutting unit motor rotor tool (part number
TOR6028) to the gear box side of the motor with four M6 – 1.0 X 16 cap
screws.
Figure 110
9. Ferrule nut
10. Connector – 2 pin
11. Wedge – 2 pin
12. Convoluted tubing – 0.63 inch
13. Cable tie (4 each)
14. Connector – 4 pin
15. Wedge – 4 pin
Page 5–139 Electrical System: Service and Repairs