Toro Greensmaster eTriFlex 3360 Service Manual page 250

Checking the Brake Adjustment (continued)
Adjusting the Brake Linkage
Chassis: Adjustments
parking brake. If the gaps do not increase when the manual parking brake is
engaged, adjust the brake cable: refer to
6–6).
1. Park the machine on a level surface, set the key switch to the O
and remove the key.
2. Loosen the hex nuts and adjust the eye bolt as far as possible to relax the
extension spring. Remove the spring.
g283623
1. Front traction motor – RH
2. Hex nut (2 each)
3. Eye bolt
3. Use the 3/8 inch square drive hole in the right side upper brake arm to fully
retract the brake actuator.
4. If either brake rod assembly was removed, repaired, or replaced:
A. Check the brake rod assembly and adjust as necessary:
B. Set the spring length to 36 to 40 mm (1.44 to 1.56 inch) and tighten
the jam nuts.
C. Set the overall length to 282 to 285 mm (11.11 to 11.23 inch) and
tighten the clevis nut.
Adjusting the Brake Cable (page
Figure 114
4. Extension spring
5. Upper brake arm – RH
6. Brake rod assembly
Page 6–4
position
FF
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B