Removing the Cutting Unit Suspension Assembly (continued)
Chassis: Service and Repairs
4. If a front suspension assembly will be removed from the machine, remove
the front wheel; refer to
5. Loosen the bulkhead nut that secures the cutting unit motor cable to the
bracket on the suspension assembly, and separate the cable from the
bracket.
6. Remove the fasteners securing the lift/lower actuator to the cutting unit
suspension.
7. Support the cutting unit motor away from the suspension assembly.
Support the suspension assembly when removing it to prevent it
from falling and causing personal injury. The suspension assembly
weighs approximately 30 kg (65 lbs).
8. Support the suspension assembly and remove the 3 flange head screws that
secure the assembly to the machine. Remove the suspension assembly.
Wheels and Tires (page
CAUTION
Page 6–46
6–9).
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B