Toro Greensmaster eTriFlex 3360 Service Manual page 313

Removing the Reel Assembly (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
2. If the cutting unit is equipped with an optional groomer or rear roller brush,
remove the drive components for those options from cutting unit. Refer to
Removing the Gear Box Assembly (page
(Optional) (page 7–30)
3. Remove the fasteners that secure the counterweights to the left side plate,
and remove the counterweights. Remove and discard the O-ring.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when removing the cutting reel.
If the reel bearings or seals are being replaced, the reel nuts must
be removed. Use the following procedure to restrain the reel and
loosen the reel nuts before removing the rollers.
4. Loosen the reel nuts:
A. Tip up the cutting unit to access the bottom of the reel.
g285245
1. Reel nut (right end shown)
2. Reel shaft
8–4), and/or
for additional information.
CAUTION
IMPORTANT
Figure 158
3. Weld side of reel support plate
4. Pry bar
Page 7–15
Rear Roller Brush
DPA Cutting Units: Service and Repairs