Toro Greensmaster eTriFlex 3360 Service Manual page 102

Removing the Engine (continued)
Installing the Engine
Engine (Model 04580): Service and Repairs
g308239
1. Cap screw
The engine assembly weighs approximately 42 kg (92 lb). Use an
appropriate lift to remove the engine assembly.
13. Remove the 4 fasteners securing the engine to the engine frame and lift
the engine from the machine.
14. Continue to disassemble the engine as necessary.
Refer to Figure 15 for this procedure.
Ensure that all parts removed from the engine during maintenance
are installed.
1. If the engine pulley was removed:
A. Apply anti-seize lubricant to the engine shaft and fit the square key and
engine pulley onto the engine shaft. Position the pulley approximately
28 mm (1.1 inch) from the engine.
B. Apply a high temperature medium strength thread locking compound
(Loctite 2422 or equivalent) to the set screws and tighten from 14 to
18 N∙m (120 to 140 in-lb).
Figure 18
2. Front engine lift lug
CAUTION
IMPORTANT
Page 4–16 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B