Toro Greensmaster eTriFlex 3360 Service Manual page 327

Assembling the Roller (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g206894
1. Seal
2. Assembly spacer
8. Tighten the bearing lock nuts until the yellow assembly washers bottom out
against the roller housing. Remove the bearing lock nuts, assembly washers,
and assembly spacers.
Note: The V-rings should be installed without any lubrication.
9. Carefully fit a dry V-ring onto each bearing lock nut.
g227754
1. Bearing lock nut
10. Lubricate the lips of the installed seals with #2 general purpose grease.
Note: If an original bearing lock nut is being used, apply a medium strength
thread locker (Loctite #242 or equivalent) to the threads of the lock nut.
11. Install the bearing lock nut with V-ring onto each end of the roller shaft.
Tighten the lock nuts to 34 to 41 N∙m (25 to 30 ft-lb).
Figure 170
3. Yellow assembly washer
4. Bearing lock nut
Figure 171
2. V-ring
Page 7–29 DPA Cutting Units: Service and Repairs