Toro Greensmaster eTriFlex 3360 Service Manual page 117

CAN bus Communications (continued)
g287505
1. CAN bus isolation module
2. CAN A – 12V side
3. CAN B– 48V side
4. CAN bus terminator resistor (4 each)
5. T1: Primary controller
6. SC1: InfoCenter
7. CAN A diagnostic port
8. T2: Cutting Unit 1 motor controller (center)
9. T3: Cutting Unit 2 motor controller (left)
10. T4: Cutting Unit 3 motor controller (right)
11. T5: Traction 3 motor controller (optional)
12. T6: Starter/Generator controller (model 03580 only)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
Note: For model 04590 machines, the SC8: Lithium-ion battery controller (BMS)
exists on the CAN bus. Each of the eight lithium-ion batteries communicates with
the BMS through a battery interface harness or sub-net. The BMS then forwards
the battery information to the rest of the machine via the CAN bus.
Figure 24
13. T6: Pre–charge controller (model 03590 only)
14. SC2: Lift/Lower 1 actuator controller (center)
15. SC2: Lift/Lower 2 actuator controller (left)
16. SC2: Lift/Lower 3 actuator controller (right)
17. SC5: Traction 1 motor controller (right)
18. SC6: Traction 2 motor controller (left)
19. SC7: Steering motor controller
20. SC8: Lithium-ion Battery controller (model 03590 only)
21. CAN B diagnostic port
22. Lithium-ion battery interface (model 03590 only)
23. Lithium-ion batteries (model 03590 only)
Page 5–13 Electrical System: Electrical System Operation