Toro Greensmaster eTriFlex 3360 Service Manual page 314

Removing the Reel Assembly (continued)
DPA Cutting Units: Service and Repairs
B. Insert a long-handled pry bar (3/8 x 12 inch with screwdriver handle
recommended) through the bottom of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move.
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
C. Move the pry bar against the weld side of the reel support plate closest to
the reel nut being loosened.
The reel nut on the left end of the cutting reel has a black finish
and has left-hand threads. The reel nut on the right end of the
cutting reel has a silver finish and has right-hand threads.
D. Rest the handle of the pry bar against the front roller and loosen the reel
nut closest to the pry bar.
E. Position the pry bar in the same manner on the opposite end of the reel
and loosen the remaining reel nut.
F. Tip the cutting unit back onto its rollers.
5. Remove the bedbar; refer to
6. Remove the front roller; refer to
7. Remove the rear roller; refer to
8. Remove the fasteners that secure the crosslink (item 15) to pitch arms and
remove the crosslink.
9. Support the cutting reel to prevent it from shifting or falling and remove the
two shoulder bolts and two flange nuts that secure either side plate to the
cutting unit frame. Remove the side plate from the cutting unit.
10. Carefully slide the cutting reel assembly (with seals, bearings and reel nuts)
from the opposite side plate. Retrieve the flat wire spring from the reel
bearing bore of the left side plate.
11. Thoroughly clean any grease and corrosion from the reel bearing bores in
the side plates. Inspect side plates and pitch arms for wear or damage and
replace components if needed.
12. Inspect the remaining cutting unit components for corrosion, wear, or damage
and replace the components as necessary.
IMPORTANT
IMPORTANT
Removing the Bedbar (page
Removing the Front Roller (page
Removing the Rear Roller (page
Page 7–16
7–6).
7–23).
7–24).
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B