Toro Greensmaster eTriFlex 3360 Service Manual page 101

Removing the Engine (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
The engine frame assembly weighs approximately 68 kg (150 lb).
Use an appropriate lift to remove the engine frame assembly.
C. Remove the engine frame assembly from the machine.
10. Remove the fasteners securing the drip pan to the engine frame (item 3
and 4 in Figure 15).
11. Remove the starter/generator drive belt:
A. Tilt the Operator seat forward and remove the pulley cover (item 6 in
Figure 15).
B. Loosen the hex nuts and extend the adjustment pin as far as possible to
relax the extension spring.
g286883
1. Generator drive belt
2. Generator pulley
3. Engine pulley
4. Engine frame
C. Loosen the 4 cap screws (item 8) securing the starter/generator to
the engine frame. Loosen the cap screws only enough to allow the
starter/generator to rotate on the engine frame.
D. Rotate the starter/generator clockwise (when viewed from above) and slip
the starter/generator drive belt off of the engine pulley.
Note: An engine lift lug is included in the machine loose parts kit.
12. Install an engine lift lug to the front of the engine.
CAUTION
Figure 17
5. Hex nut (2 each)
6. Adjustment pin
7. Extension spring
8. Cap screw (4 each)
Page 4–15 Engine (Model 04580): Service and Repairs