Toro Greensmaster eTriFlex 3360 Service Manual page 349

Servicing the Groomer Reel (continued)
g285716
1. Groomer reel shaft
2. Groomer blade (40 each)
3. Spacer (39 each)
4. Locknut (2 each)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
blades to put the sharpest blade edge forward. The blades that are rounded to
the midpoint of the blade tip must be reversed or replaced for best groomer
performance.
1. Park the machine on a clean and level surface, lower the cutting unit, set the
key switch to the O
2. Remove the groomer reel from the cutting unit; refer to
Groomer Reel (page
3. Remove the lock nut from either end of the groomer reel shaft.
4. Remove the blades and from the groomer shaft. If necessary, remove
second lock nut from the shaft.
5. Inspect and replace worn or damaged components.
6. Assemble the groomer reel as follows:
Note: New lock nuts have an adhesive patch to prevent the lock nut from
loosening. If a used lock nut is being installed, apply a medium strength
thread locker (Loctite #242 or equivalent) to the threads of the lock nut.
A. Install a lock nut on one end of the groomer reel shaft.
B. Install a groomer blade against the lock nut.
C. Install the remaining spacers and blades in an alternating manner making
sure that all blades are separated by a spacer.
D. When all the blades have been installed, install the second lock nut onto
the shaft. Center the blades and spacers on the shaft by adjusting the
lock nuts.
E. Use the through holes in shaft to prevent the shaft from rotating and
tighten the second lock nut to 42 to 48 N∙m (31 to 35 ft-lb). After
Figure 186
5. Rounded edge
6. Midpoint
7. Centered on shaft
position and remove the key from the key switch.
FF
8–14).
Page 8–15 Universal Groomer (Optional): Service and Repairs
Removing the