Toro Greensmaster eTriFlex 3360 Service Manual page 333

Drive and Support Components (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
The brush drive belt may fail prematurely if the pulleys are not
properly aligned.
10. Using a straight edge, determine the number of spacers necessary under the
driven pulley to align the pulleys. Tighten the lock nut securing the driven
pulley from 20 to 26 N∙m (15 to 19 ft-lb).
g285394
(shown with Universal Groomer installed)
1. Straight edge
11. Install and adjust the drive belt and install the cover.
If brush to roller contact is incorrect, brush operation will be
adversely affected.
12. Check that the roller brush is parallel to the rear roller within 0.25 mm (0.010
inch) clearance to light contact. Adjust the bearing brackets as necessary.
IMPORTANT
Figure 176
IMPORTANT
Page 7–35 DPA Cutting Units: Service and Repairs