Toro Greensmaster eTriFlex 3360 Service Manual page 170

Testing the Location ID Module (continued)
Electrical System: Testing the Electrical Components
7. If the ID module tests correctly and a circuit problem still exists, check the
wire harness:
A. Use a multimeter (ohms setting) to measure and record the resistance
across the disconnected machine wire harness connector terminals.
g287900
1. Machine wire harness connector
B. The resistance across connector terminal F (black/white wire) and each
of the terminals C, D, and E should be 18k to 20k ohms. If the machine is
equipped with an optional rear wheel traction motor, resistance across
connector terminal F and B should also be 18k to 20k ohms.
C. An incorrect resistance measurement across a pair of terminals indicates
damage to the wire harness for that motor circuit. Repair or replace the
wiring as necessary; refer to
8. Connect the location ID module to the machine wire harness after testing.
9. Connect the 48V battery disconnect.
Figure 68
Appendix A (page
Page 5–66
A–1).
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B