Toro Greensmaster eTriFlex 3360 Service Manual page 104

Installing the Engine (continued)
Engine (Model 04580): Service and Repairs
6. If the engine was removed from the machine separately, proceed to step
8 of this procedure. If the entire engine frame assembly (including the
starter/generator) was removed:
A. Secure the 3 engine frame assembly isolation mounts to the machine
with the fasteners previously removed.
B. Connect the machine wire harness to the starter/generator.
7. Install the clamp securing the engine oil drain hose to the right side battery
tray.
8. Connect the choke control cable to the engine:
A. Set the choke control at the operator control panel to the full choke
position.
B. Connect the choke control cable to the choke lever at the carburetor.
C. Set the choke lever at the carburetor to the full closed position and
secure the cable housing to the engine with the clamp and cap screw
previously removed.
9. Connect the electrical system wiring to the engine:
• The wire harness ground at the engine (near front left engine mount).
• The engine wire harness connector at the main wire harness (left side
of engine).
10. Connect the evaporative control system carbon canister to the engine vent
hose.
11. Install the fuel tank; refer to
12. Install the exhaust system; refer to
13. Ensure that all the hoses, tubes, and wires are clear of moving parts and
secured to their original locations.
14. Connect the negative (–) battery cable at the 12V system battery (model
04580).
15. Check engine oil level and adjust if necessary; refer to traction unit Operator's
Manual.
16. Operate the machine. Check for proper engine operation. Check for fuel
leaks and correct any issues before returning the machine to service.
Installing the Fuel Tank (page
Installing the Exhaust System (page
Page 4–18
4–4).
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
4–11).