Servicing the Groomer Reel (continued)
Installing the Groomer Reel
Universal Groomer (Optional): Service and Repairs
tightening the lock nut, spacers should not be free to rotate and the
groomer blades should be centered on the shaft.
7. Install the groomer reel back onto the cutting unit; refer to
Groomer Reel (page
1. Position the cutting unit on a level surface. If the cutting unit is attached to
the traction unit, lower the cutting unit, set the key switch to the O
and remove the key from the key switch.
2. Position the groomer reel between the groomer driven and stub shafts.
3. Secure the groomer reel to the cutting unit with the 4 jam nuts, 4 bolts, and 4
shaft clamps. Tighten the bolts from 5 to 7 N∙m (45 to 60 in-lb).
4. Check the groomer reel height and mower height-of-cut settings and adjust
as necessary.
8–16).
Page 8–16
Installing the
position
FF
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B