Toro Greensmaster eTriFlex 3360 Service Manual page 225

Removing the Starter/Generator Assembly
g286730
1. Engine frame assembly
2. Cap screw
3. Cap screw ( 2 each)
4. Isolating mount – rear
5. Lock nut (3 each)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
6. Cap screw
7. Clamp
8. Lock nut
9. Flange nut (4 each)
10. Wire harness connector
Refer to Figure 99 for this procedure
1. Park the machine on a level surface, lower the cutting units, set the key
switch to the O position and remove the key from the key switch.
FF
2. Unplug the 48V battery disconnect; refer to
5–9).
3. Disconnect the negative (–) battery cable from the 12V system battery; refer
to Removing and Installing the 12V System Battery (Model 04580) (page
5–105).
4. Remove the exhaust system; refer to
4–10).
Figure 99
11.
12.
13.
14.
Removing the Exhaust System (page
Page 5–121
Isolating mount – front (2 each)
Cap screw (4 each)
Flat washer (3 each)
Cap screw (2 each)
48V Battery Disconnect (page
Electrical System: Service and Repairs