Toro Greensmaster eTriFlex 3360 Service Manual page 246

Assembling the Cutting Unit Motor (continued)
Installing the Cutting Unit Motor
Electrical System: Service and Repairs
g289245
1. Output gear
2. Gear box cover
14. Lubricate new O-rings with dielectric lubricant and install the O-rings into
the grooves in the gear box cover.
The output shaft splines can be sharp; be careful not to damage the
lip seal when installing the gear box cover.
15. Carefully install the gear box cover and secure it with the six cap screws
previously removed. Tighten the screws from 8 to 9 N·m (70 to 80 in- lb).
1. Install a new O-ring to the flange of the cutting unit motor.
2. Coat the splines of the cutting unit motor shaft with No. 2 multipurpose
lithium base grease.
3. Install the cutting unit motor to the cutting unit; refer to the traction unit
Operators Manual.
4. Position the cutting unit motor cable into the bulkhead brackets on the
machine (2 per motor cable) and tighten the bulkhead nuts.
5. Connect the two cutting unit motor cable connectors to the machine wire
harness and connect the 48V battery .
6. If the cutting unit motor is new, update the machine software; contact an
Authorized Toro Distributor for assistance.
Figure 112
3. Lip seal
IMPORTANT
Page 5–142 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B