Drive and Support Components (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g285506
1.
Drive shaft assembly
2.
Reel shaft
B. Insert a long-handled pry bar (3/8 x 12 inch with screwdriver handle
recommended) through the bottom of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move.
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
C. Move the pry bar against the weld side of the reel support plate closest
to the rear roller brush drive shaft.
D. Rest the handle of the pry bar against the front roller and use the large
hex (1.375 inch) to loosen the drive shaft assembly.
E. Tip the cutting unit back onto its rollers.
F. Clean the threads in the end of the reel shaft. A right-hand thread
and left-hand thread tap is available to clean or repair the threads if
necessary; refer to
Figure 174
3.
Weld side of reel support plate
4.
Pry bar
IMPORTANT
Reel Thread Repair Taps (page
Page 7–33
2–15).
DPA Cutting Units: Service and Repairs