Toro Greensmaster eTriFlex 3360 Service Manual page 317

Installing the Reel Assembly (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
g285246
1. Reel nut (right end shown)
2. Reel shaft
B. Move the pry bar against the weld side of the reel support plate closest to
the reel nut being tightened.
The reel nut on the left end of the cutting reel has a black finish
and has left-hand threads. The reel nut on the right end of the
cutting reel has a silver finish and has right-hand threads.
C. Rest the handle of the pry bar against the front roller and tighten the
reel nut closest to the pry bar. Tighten the reel nut from 123 to 149 N·m
(90 to 110 ft-lb).
D. Position the pry bar in the same manner on the opposite end of the reel
and tighten the remaining reel nut.
E. Fill the reel nut splines with high temp Mobil XHP−222 grease or
equivalent.
11. Check to make sure the rear roller and cutting reel are parallel; refer to
Leveling the Rear Roller (page
12. Install a new O-ring on the counterweight assembly and secure the
counterweights to the right side plate with the fasteners previously removed.
IMPORTANT
Figure 160
3. Weld side of reel support plate
4. Pry bar
IMPORTANT
7–4).
Page 7–19 DPA Cutting Units: Service and Repairs