Toro Greensmaster eTriFlex 3360 Service Manual page 282

Removing the Steering Arm (continued)
Installing the Steering Arm
Chassis: Service and Repairs
1. Park the machine on a level surface, set the key switch to the O
and remove the key.
2. Remove the cover (item 21) and disconnect the steering input device from
the machine wire harness. Check the steering input device and the harness
connector for damage or corrosion and clean or repair as necessary.
Note: The steering wheel, steering input device, and steering mount may
be removed from the steering arm as an assembly if desired. Record the
position of the steering mount for assembly.
3. Remove the steering input device if necessary:
A. Remove the screw securing the cap to the steering wheel.
B. Remove the hex nut and flat washer securing the steering wheel to the
shaft.
C. Use a suitable puller to remove the steering wheel from the steering input
device.
D. Remove the fasteners securing the steering input device to the steering
mount and remove the steering input device.
Note: If the steering input device is being replaced, remove or replace
the shaft adapter (item 11). The shaft adapter is secured to the steering
input device with a roll pin and 2 set screws. Discard the roll pin.
4. Record the position of the steering mount (item 6) for assembly and remove
if necessary.
The gas cylinder is under high pressure at all times. Avoid pressing
the gas cylinder release pin while either end of the cylinder is not
secured to the machine. Do not open the gas cylinder.
5. Remove the gas cylinder:
A. Remove the retaining ring and the pivot pedal (item 32).
B. Support the steering arm assembly.
C. Remove the fasteners securing the gas cylinder at the steering arm.
D. Remove the retaining ring (item 27) then remove the pivot lever and gas
cylinder as an assembly.
E. Loosen the jam nut and separate the gas cylinder from the pivot lever if
necessary.
6. Remove the fasteners securing the steering arm to the chassis and remove
the steering arm.
7. Inspect the steering arm pivot spacer (item 2) and the pivot lever bushings
(item 26) and (item 31) the for wear and replace if necessary.
Refer to Figure 136 for this procedure.
1. If the right side platform support (item 29) was removed from the machine,
tighten the support fasteners from 102 to 115 N·m (75 to 85 ft-lb).
2. Secure the steering arm to the chassis.
CAUTION
Page 6–36
position
FF
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B