Toro Greensmaster eTriFlex 3360 Service Manual page 258

Removing the Front Traction Gear Box (continued)
Installing the Front Traction Gear Box
Chassis: Service and Repairs
7. Locate and retrieve the 2 dowel pins.
8. Use a new O-ring and install the drain plug.
Refer to Figure 122 for this procedure.
1. Remove any residual gasket material from the gear box and wheel motor
gasket surfaces.
2. Fit the dowel pins and a new gasket in position and install the gear box.
3. Apply a medium strength thread locking compound (Loctite 243 or equivalent)
to the 10 cap screws (item 7) and install them loosely.
A. Tighten the cap screws in a crossing pattern from 10 to 12 N·m (90 to
110 in-lb).
B. Tighten the cap screws in a crossing pattern from 18 to 22 N·m (160 to
200 in-lb).
C. Retighten the cap screws in a clockwise pattern from 18 to 22 N·m (160
to 200 in-lb).
4. Apply a medium strength thread locking compound (Loctite 243 or equivalent)
to the cap screw (item 5). Install the washer and cap screw, then tighten the
cap screw from 23 to 28 N·m (17 to 21 ft-lb).
5. Apply a light coating of grease to a new O-ring and install it on the plug (item
3), then install the plug.
6. Remove the vent fitting (item 13) and fill the gear box with 385 cc (13
ounces) of 80W-90 gear oil (Mobilube HD Plus 80W-90 or equivalent).
Install the vent fitting.
7. Install the front wheel hub; refer to
Hubs (page 6–10).
8. Install the front wheel; refer to
Hubs (page 6–10).
9. Test traction operation and check for leaks before returning the machine to
service.
Removing and Installing the Front Wheel
Removing and Installing the Front Wheel
Page 6–12 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B