Toro Greensmaster eTriFlex 3360 Service Manual page 251

Adjusting the Brake Linkage (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g283626
1. Brake rod
2. Brake rod spring
3. Jam nut (2 each)
4. Upper brake rod clevis
D. Use new cotter pins and install the brake rod assembly to the upper
brake arms only.
5. Remove the cotter pin and clevis pin from the lower brake rod clevis. Discard
the cotter pin.
Adjust each brake rod individually.
6. Loosen the hex nut at the upper brake rod clevis and adjust the brake rod
so the hole in the lower brake rod clevis is just below the top of the slot in
the brake lever.
g283628
1. Front traction motor – RH
2. Lower brake rod clevis
Figure 115
5. Clevis nut
6. Washer
7. Lower brake rod clevis
8. Clevis pin
IMPORTANT
Figure 116
(view from rear)
3. Brake lever
Page 6–5 Chassis: Adjustments