Toro Greensmaster eTriFlex 3360 Service Manual page 326

Assembling the Roller (continued)
DPA Cutting Units: Service and Repairs
Failure to grease bearing lock nut before seal installation may result
in seal damage.
5. Fill the seal 75 to 90% full with #2 grease and apply a coating of grease to
the underside of the bearing lock nut to prevent damaging the seal damage
during installation. Carefully fit a seal onto each bearing lock nut.
g206892
1. Seal
6. Install a bearing lock nut with seal onto each end of the roller shaft. Tighten
the bearing lock nuts until they bottom against the bearings. Remove the
bearing lock nuts and clean away any grease.
g206893
1. Seal
7. Position an assembly spacer and yellow assembly washer on each end of
the roller shaft.
IMPORTANT
Figure 168
2. Bearing lock nut
Figure 169
2. Bearing lock nut
Page 7–28 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B