Toro Greensmaster eTriFlex 3360 Service Manual page 90

Removing the Fuel Tank
Installing the Fuel Tank
Engine (Model 04580): Service and Repairs
Gasoline is highly flammable and explosive. A fire or an explosion
from the fuel can burn you, burn other people, and damage property.
• Use caution whenever you store or handle gasoline.
• Do not smoke while handling gasoline.
• Do not fill the fuel tank while the engine is running, while the
engine is hot, or when the machine is in an enclosed area.
• Always fill the fuel tank outside and wipe up any spilled gasoline
before starting the engine.
• Store gasoline in a clean, safety-approved container and keep
the cap in place.
• Use gasoline as an engine fuel only, not for any other purpose.
The muffler and exhaust manifold may be hot. To avoid possible
burns, allow exhaust system to cool before working on the engine.
Refer to Figure 9 for this procedure.
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, remove the key from the key switch and unplug the 48V battery
disconnect.
2. Open or remove the hood; refer to
Assembly (page 6–43).
3. Close the fuel shut-off valve.
4. Allow the engine to completely cool.
5. Use a siphon or pump to empty the fuel tank.
6. Disconnect the fuel vent hose and fuel supply hose from the top of the fuel
tank.
7. Lift the evaporative control system carbon canister from its bracket on the
fuel tank.
8. Remove the four flange nuts and clamps securing the fuel tank to the vehicle
frame and remove the fuel tank.
9. Inspect the foam pads at the fuel tank mounts and replace them if damaged.
Refer to Figure 9 for this procedure.
1. Secure the fuel tank to the vehicle frame with the clamps and flange nuts
previously removed.
2. Secure the evaporative control system carbon canister in its bracket on the
fuel tank.
3. Connect the fuel supply hose to the top of the fuel tank and secure with
the hose clamp.
4. Connect the fuel vent hose to the top of the fuel tank and secure with the
hose clamp. Make sure that the hose is not kinked or obstructed.
DANGER
CAUTION
Removing and Installing the Hood
Page 4–4 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B