Toro Greensmaster eTriFlex 3360 Service Manual page 270

Replacing the Brake Cable (continued)
Removing and Installing the Brake Linkage
g283329
1. Hex nut (2 each)
2. Eye bolt
3. Hair pin (2 each)
4. Flange nut (4 each)
5. Bearing (2 each)
6. Cap screw (4 each)
7. Roll pin (2 each)
8. Upper brake arm – RH
9. Brake shaft
10. Upper brake arm – LH
Chassis: Service and Repairs
4. Loosen the 2 adjuster jam nuts at the brake adjuster and remove the cable
from the adjuster bracket.
5. Disconnect the brake cable from the left side brake arm.
6. Install the new cable in the reverse order.
7. Adjust the brake cable; refer to
11. Cotter pin (5 each)
12. Clevis – actuator
13. Clevis pin (2 each rod)
14. Upper clevis – brake rod
15. Hex nut (3 each rod)
16. Brake rod
17. Washer (2 each rod)
18. Spring
19. Lower clevis – brake rod
20. Brake rod assembly (2 each)
Adjusting the Brake Cable (page
Figure 131
21.
22.
23.
24.
25.
26.
27.
28.
Page 6–24
6–6).
Clevis pin
Retaining ring
Brake cable
Pin – actuator
Electric brake actuator
Clevis pin
Link
Extension spring
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B