Toro Greensmaster eTriFlex 3360 Service Manual page 307

Removing the Bedbar Adjuster
Installing the Bedbar Adjuster
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
g285044
1. Lock nut
2. Compression spring
3. Washer
4. Bedbar adjuster screw
5. Retaining ring
1. Remove bedbar; refer to
2. Remove the lock nut, compression spring and washer from the bedbar
adjuster screw.
Note: The bedbar adjuster shaft has left-hand threads.
3. Unscrew the bedbar adjuster shaft from the bedbar adjuster screw.
4. Remove the retaining ring and wave washer from the adjuster shaft and
remove the adjuster shaft.
5. Inspect the flange bushings in the cutting unit side plate and replace them
if necessary.
6. Inspect the detent and replace it if necessary.
1. If previously removed, secure the detent to the side plate.
2. If previously removed, align the key on the flange bushings to the slots in the
cutting unit frame and install.
3. Slide adjuster shaft into flange bushings and secure with wave a washer
and a retaining ring.
Note: The bedbar adjuster shaft has left-hand threads.
4. Apply anti-seize lubricant to the threads of the bedbar adjuster screw that
fit into adjuster shaft (the left hand threads) and thread the bedbar adjuster
screw into the adjuster shaft.
Figure 152
6. Wave washer
7. Flange bushing (2 each)
8. Bedbar adjuster shaft
9. Detent
10. Cap screw
Removing the Bedbar (page
Page 7–9
7–6).
DPA Cutting Units: Service and Repairs