Sheeting Off Mechanism : Mechanical Alignment - MUTOH SC-550 Maintenance Manual

6.2.10. Sheeting off mechanism : mechanical alignment.

(Not for SC-550)
Note :
It is recommended to check the mechanical alignment of the sheeting off mechanism
before running the electronic adjustment procedure.
Step 1 : Make sure the machine is powered off.
Step 2 : Open the transparent cover and remove the head cover.
Step 3 : Check if lever #2 (Please refer to picture mentioned below) can move freely up/down and
front/backwards. The lever should return always to the Up position and to the backwards position
by the spring tension.
Also check if the blade moves up and down freely and returns in the up position by the spring
tension.
Step 4 : With your right hand move the tool holder to the most up position, with your left hand push the
lever (#2) inside and check the clearance between bracket #3 and lever "2. (Please refer to the
picture mentioned below)
This distance should be 1 mm –0.5 mm.
If this is not the case, use a small pair of pliers and bend the bracket #3 until the correct
clearance is obtained.
Step 5 : Install the head cover and make the electronic alignment in diagnostic mode.
Maintenance Manual – SC Cutting Plotter
59 AP-74030, Rev / B