Force Configuration Restore - HP Aruba JL253A Management And Configuration Manual

non-blocking
recovery-mode
verbose
switch(config)# cfg-restore flash add non-blocking
diff
force
recovery-mode

Force configuration restore

The cfg-restore command fails if a reboot is required. The Configuration restoration is not
allowed as the configuration has reboot required commands error is displayed, along with lines
requiring a reboot. The force option in the cfg-restore command allows a user to force a reboot. The
command is: cfg-restore {flash | tftp | sftp} <FILE-NAME> force.
Before reboot, config is the active configuration. After the device reboots, the backup file becomes the new
active configuration.
id | act pri sec | name
---+-------------+---------------
1 | * *
2 |
3 |
4 |
5 |
switch(config)# cfg-restore flash golden_config
Current running-configuration will be replaced with 'golden_config'.
Continue (y/n)? y
Configuration restore is in progress, configuration changes are temporarily
disabled.
Configuration restoration is not allowed as the configuration has reboot required commands.
switch(config)# show cfg-restore status
Status
Config File Name
Source
Time Taken
Last Run
Recovery Mode
Failure Reason
Command : console terminal none
Number of Add Commands
Number of Remove Commands : 1
Time Taken for Each Phase :
Calculating diff
Adding commands
Removing commands
switch# cfg-restore flash golden_config force
Device may be rebooted if the configuration file has reboot required or
system-wide change commands. Do you want to continue
Current running-configuration will be replaced with 'golden_config'.
Continue (y/n)?
Configuration restore is in progress, configuration changes are temporarily
disabled.
Successfully applied configuration 'golden_config' to running configuration.
Rebooting switch...
562
system-wide change commands present.
Config restoration in non-blocking mode.
To enable/disable recovery-mode.
Provide the details of config restore status and the list of commands to be added
or deleted.
Provide the list of changes that will be applied on
the running configuration.
Apply the configuration with reboot if the configuration has reboot required commands or
system-wide change commands present.
To enable/disable recovery-mode.
* | config
| def
| golden_config
|
|
: Failed
: golden_config
: Flash
: 5 Seconds
: Mon Oct 30 23:03:19 2017
: Enabled
: Reboot required commands present.
: 0
: 3 Seconds
: 0 Seconds
: 0 Seconds
(y/n)?
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08