Table of Contents
Advertisement
exit
switch(config)#
Show commands to show the SHA of a configuration
The show commands provide SHA details of the running and startup configurations.
show hash
Syntax
show {config | running-config} hash {recalculate}
Description
Shows SHA ID of startup or running configuration.
Command context
config
Examples
switch# show config
config
files
hash
interface
oobm
To display the hash calculated for the startup configuration:
switch(config)# show config hash
The hash must be calculated.
Continue (y/n)? y
Calculating hash...
Startup Configuration hash:
4f66 8b77 6b66 e5fb 0c12 f7fb 8ea6 b548 af2e 2e03
This hash is only valid for comparison to a baseline hash if
the configuration has not been explicitly changed (such as
with a CLI command) or implicitly changed (such as by the
removal of a hardware module).
switch(config)# show config hash
recalculate
switch(config)# show config hash recalculate
Startup Configuration hash:
4f66 8b77 6b66 e5fb 0c12 f7fb 8ea6 b548 af2e 2e03
This hash is only valid for comparison to a baseline hash if
the configuration has not been explicitly changed (such as
with a CLI command) or implicitly changed (such as by the
removal of a hardware module).
574
List saved configuration files.
Display the hash calculated for the startup
configuration.
Show the startup configuration for interfaces.
Show the startup configuration for OOBM.
This may take several minutes.
Calculate hash (if needed) without prompting.
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
Advertisement
Table of Contents
Troubleshooting
